Software Design - Rough Software Loop

Focusing on the software design, the team came up with a rough look at the software loop.


The components of the software loop will be referred to in upcoming software blog posts.

Comments

Post a Comment

Popular posts from this blog

Software Design - Arduino <-> Raspberry Pi Interfacing - RPi Communication Protocol

Image
This blog post focuses on the interactions between the Arduino and the Raspberry Pi. More specifically, the serial communication protocol being used between the two modules. Check out the post on the Overview of Architecture to refresh your memory on the components connected to each of the modules. Starting with the Raspberry Pi, this is our command hub. All commands are sent from the RPi, based on the current state of the robot. This could essentially be considered as the 'brains' of our pod. A command packet is sent from the RPi to the Arduino, consisting of 10 floats, with a start and end byte to locate the start and end of the message. The RPi command packet can be seen in the following figure. Briefly walking through each of the commands in the packet, the intended state of the pump is the first float sent in the package (i.e. whether the pump should be pumping water out of the chamber (ON) or not (OFF)). Next, the bulb state is sent, turning the bulbs ON or OFF ...
Read more

Mechanical Design - Watertight Locking Mechanism

Image
To solve the issue of protecting the electronics from water damage from the external water body, several locking mechanisms were explored, connecting the middle interface (i.e. spectroscopy chamber and internal water flow), the bottom interface (pump and mesh) and the top interface (pad and flotation devices). This was explored in a manner which would ensure no water would flow between the connecting parts. Below is a rendering of the chosen locking mechanism: The above part was meant to serve as a prototype, where a latch from the above part would lock under a solid extrusion in the bottom part, similar to a tupperware container. Based on this prototype, the locking mechanism would be placed at three calculated points around the circumference of the entire Lilypod, for each interface between connecting parts (i.e. three for each interface). This prototype was sent for 3D printing to be tested. Check back on the outcome of this test!
Read more

Software Design - Arduino <-> Raspberry Pi Interfacing - Arduino Communication Protocol

Image
Moving onto the Arduino communication protocol, the following data package is sent back to the Raspberry Pi, upon receiving a command package. To keep everything consistent, there are 10 floats sent between the Arduino and the RPi. Only 5 out of the 10 floats in the data packet are populated, after a certain actuation or reading is conducted. First, the state of the garage door (i.e. opening or closing) is recorded, as well as the state of the trap door. Three floats correspond to sensor readings, including the pH sensor value, the conductivity sensor value and the ultrasonic sensor voltage values (recommending whether the filter should be cleaned out). It is important to note that the RPi decides what routine step it is on, and then builds its command packet to be sent to the Arduino. Once the Arduino obtains this command packet, and conducts the required polling and actuations, the data packet is sent back to the RPi. The RPi then logs any important data on the Firestore datab...
Read more